imagistics ipc1-im8130 Administrator's Manual page 280

Possible Cause
Networking
(protocol)
limitations or errors
Unreachable
network segment
ipc1-im8130 Administrator's Guide
the steps, contact a Imagistics authorized dealer for further
assistance.
Troubleshooting Checklist
Device Discovery
Check
1 Confirm that the protocol suite
installed on the client workstation
has been updated with the latest
software for the given operating
system. If your network only
supports the IPX/SPX protocol,
make sure that the most current
version of Novell Client software
is installed.
2 Print a ipc1-im8130 startup page
from the copier. Does the ipc1-
im8130 controller support the
same protocol as the network?
3 Change the protocol settings
from the copier's control panel, if
necessary, and reboot the ipc1-
im8130 for the changes to take
effect. Repeat step 2. Was the
device discovered?
4 Check the ipc1-im8130 startup
page. Are the IP Address and
subnet mask settings correct?
5 Check the router to make sure it
is not filtering out the ipc1-
im8130 packets. Is the router
processing ipc1-im8130 packets
correctly?
6 Can another workstation within
the same network segment
discover the ipc1-im8130
controller?
For
Instructions,
Yes No Go To...
→
See the vendor's
Next
Step
Web site for
↓
information about
product updates
and technical
support.
→
Modifying
Next
Step
Controller
↓
Settings at the
Control Panel
page 43.
End Modifying
Next
Step
Controller
↓
Settings at the
Control Panel
page 43.
→
Modifying
Next
Step
Controller
↓
Settings at the
Control Panel
page 43.
→
Next Adjust the router
Step
settings.
↓
→
Network
Next
Step
Connectivity
↓
Problems
page 276.
on
on
on
on
281