Step 9 - Connect Sources And Initial Power Up - Christie CP2000-ZX Setup Manual

STEP 9 - Connect Sources and Initial Power Up

Once the lamp is installed, the projector is essentially ready for operation. Although an image is not required at
this time, it is recommended external cinema servers and sources be connected. See
Sources.
Before igniting the lamp for the first time, it is essential that you do the following to ensure successful
communication with the projector:
1. Assign the projector with a unique IP address. Each projector is given a default IP address, however if
you are connecting the projector to an existing network you must give it a new IP address. For first time
installations, assign the IP address in the Configuration / Administrator menu via the Control Display
Panel (CDP).
2. Set the baud rate. From the CDP Configuration menu, set the baud rate to match the external device
connected (such as a server). The projector's default baud rate is 9600 Kbps.
3. Enter details of the lamp. From the CDP Lamp menu, select Lamp Change and define the type of lamp
installed, serial number and number of hours logged on the lamp (if any).
4. Power-up the projector. With all components installed and connected, power-up the projector as
described in
5. Perform LampLOC™ alignment on the newly installed lamp. This ensures the lamp is positioned
correctly to achieve maximum light output. See
6. Perform initial optical alignment in order to optimize images displayed on screen. These adjustments
must be done before boresight adjustments. See
7. Adjust optical components when needed. In rare instances, the installer may have to adjust one or more
optical components. See
CP2000-ZX Setup Guide
020-100098-04 Rev. 1 (06-2009)
Section 3.3 Powering Up the
Section 2.8 Fold Mirror and Convergence Adjustments
Projector.
Section 2.5 Maximizing Light Output
Section 2.6 Basic Image Alignment
Section 2: Installation & Setup
Section 2.2 Connecting
for instructions.
for instructions.
for instructions.
2-9