Initial Power Up - Christie CP2000 Setup Manual

Section 2: Installation and Setup
3. On each side of the rear opening in the pedestal, loosen the two bolts securing the rear extender
legs to the projector (Figure 2-31).
4. Slide the legs out to the desired position and secure with two bolts.
5. Remove the jack.
6. If necessary, re-adjust all leveling feet for side-to-side leveling. You may have to adjust level more
precisely once an image is present.
2.5

INITIAL POWER UP

1. With all components installed and connected, power-up the projector, as described in
Up Procedure/Steps 1 and
IMPORTANT! Do not ignite the lamp until the lamp type is defined in the TPC Install menu (Step 6).
2-22
F 2-31 A R
IGURE DJUST EAR
2.
E L
XTENDER EGS
3.1 Power-
CP2000 Setup Guide
020-100070-01 Rev. 1 (10/08)