Initial Power-Up; Adjust Rear Extender Legs - Christie CP2000 User Manual

2.7

Initial Power-up

LIT MAN USR CP2000
020-100032-04 Rev. 1 (03/14)
Figure 2.29. Adjust rear extender legs
7. Slide the legs out to the desired position, and secure with 2 bolts.
8. Remove the jack.
9. If necessary, re-adjust all leveling feet for side-to-side leveling (Figure 2.28).
Note that you may have to adjust level more precisely once an image is present.
1. Turn on breakers
With all components installed and connected, power-up the projector as described in
3.2, Power-up Procedure, Steps 1 and 2. Do not ignite the lamp yet.
IMPORTANT: Do not ignite the lamp until you have defined the lamp type in the
TPC Install menu (Step 6).
2. Fill Reservoir a Second Time
Upon initial power up, your first supply
of coolant will drain into the hoses and
fill them, leaving the reservoir itself
almost empty. Using Christie's 50/50
mix of distilled water and ethylene
glycol, re-fill the reservoir until the level
is close to but not above the top mark
on the gauge located on the outside of
the pedestal door (see right). If you
over-fill, remove the reservoir from the
pedestal and pour out excess. Refer back
INSTALLATION AND SETUP
Figure 2.30. Re-fill and Check Level
2-23