Ils-Ils Setup - Christie CineLife+ 4 Series Technical Reference

Command Description
ILF+CHAN "<file>" Sets the ILS file for the specified channel.
"<channel>"
Examples
Return the ILS file in use by the system:
(ILF?)
Result:
(ILF! "ILS Scope")
Return a list of all available ILS files:
(ILF?L)
Result:
(ILF!L001 001 000 "ILS Scope")
(ILF!L001 001 001 "ILS Flat")
...
Set the active ILS file:
(ILF "ILS Flat")
Return the ILS file used by the specified channel:
(ILF+CHAN? "Media Block Flat")
Result:
((ILF+CHAN! "ILS Flat")
Set the ILS Flat file as the ILS file for the specified channel:
(ILF+CHAN "Media Block Flat" "ILS Flat")
ILS–ILS Setup
Calibrates and resets the intelligent lens system (ILS).
Parameters
• Access level: Operator
• Power level (minimum): Power Up
Commands
Command Description
ILS+CALB 1 Performs a full calibration on the ILS.
ILS+CSTS? Returns the status of the calibration. (Read-only)
0 = Completed.
1 = In progress.
CineLife+ Technical Reference–Serial Commands
020-103075-05 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
™
CineLife+ serial commands
Values
file = Name of a valid ILS file
channel = Name of a valid channel
Values
1
—
14