Replace The Lens On An Ils Lens Mount - Christie J Series Service Manual

4.8.9 Replace the Lens on an ILS Lens Mount

Remove the Lens
(1 minute)
1. Place a lens cap over the end of the lens to protect it from damage.
2. Rotate the lens locking lever counter clockwise to unlock the lens.
3. Pull the lens straight out of the lens mount.
Install the Lens
NOTICE! Remove the rear lens cap from the lens. Keep the front lens cap on the lens to protect it during
installation.
1. Rotate the lens locking lever counter clockwise to open the lens lock.
2. Line up the lens connector with the lens mount connector at the bottom
of the lens mount.
3. Insert the lens slowly and make sure the mounts on the lens are lined
up with the recessed plates on the lens mount.
4. Let the magnet pull the lens into place.
5. Rotate the lens locking lever clockwise to lock the lens into place.
NOTE: The security screws can be added for extra lens retention.
J Series 1000W and 1200W Service Manual
020-100725-04 Rev. 1 (07-2015)
Section 4: Parts and Module Replacement
4-23