Dell Networking 2024 Reference Manual page 147

Command
nsf helper strict-lsa-
checking
nsf restart-interval
network area
passive-interface
passive-interface default
passive-interface
redistribute
router-id
router ospf
show ip ospf
show ip ospf abr
show ip ospf area
show ip ospf asbr
show ip ospf database
show ip ospf database
database-summary
show ip ospf interface
Description
Set an OSPF helpful neighbor exit helper mode
whenever a topology change occurs.
Configures the length of the grace period on the
restarting router.
Enables OSPFv2 on an interface and sets its area
ID if the IP address of an interface is covered by
this network command.
Sets the interface or tunnel as passive.
Enables the global passive mode by default for all
interfaces.
Sets the interface or tunnel as passive.
Configures OSPF protocol to allow redistribution
of routes from the specified source
protocol/routers.
Sets a 4-digit dotted-decimal number uniquely
identifying the router OSPF ID.
Enters Router OSPF mode.
Displays information relevant to the OSPF
router.
Displays the internal OSPF routing table entries
to Area Border Routers (ABR).
Displays information about the identified OSPF
area.
Displays the internal OSPF routing table entries
to Autonomous System Boundary Routes
(ASBR).
Displays information about the link state
database when OSPF is enabled.
Displays the number of each type of LSA in the
database for each area and for the router.
Displays the information for the IFO object or
virtual interface tables.
Command Groups
a
Mode
ROSPF
ROSPF
ROSPF
IC
ROSPF
ROSPF
ROSPF
ROSPF
GC
PE
PE
PE
PE
PE
PE
PE
147