Ip Http Authentication - Dell Networking 2024 Reference Manual

password — Password for this level (Range: 8- 64 characters). The special
•
characters allowed in the password include ! # $ % & ' ( ) * + , - . /
: ; < = > @ [ \ ] ^ _ ` { | } ~. User names can contain blanks if
the name is surrounded by double quotes.
• encrypted — Encrypted password entered, copied from another switch
configuration.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
The DNOS firmware emulates industry standard behavior for enable mode
authentication over SSH and telnet. The default enable authentication
method for telnet and SSH uses the enableNetList method, which requires an
enable password. If users are unable to enter privileged mode when accessing
the switch via telnet or SSH, the administrator will need to either change the
enable authentication method, e.g. to enableList, or set an enable password.
If the encrypted parameter is specified, the password parameter is stored as
entered in the running-config. No attempt is made to decode the encrypted
password.
Example
The following example defines password "xxxyyyzzz" to control access to user
and privilege levels.
console(config)# enable password xxxyyyzzz

ip http authentication

Use the ip http authentication command in Global Configuration mode to
specify authentication methods for http server users. To return to the default,
use the no form of this command.
232
AAA Commands