Dell Networking 2024 Reference Manual page 142

Command
ip pim rp-candidate
ip pim sparse-mode
ip pim ssm
show ip multicast
show ip pim boundary
show ip multicast interface
show ip mroute
show ip mroute group
show ip mroute source
show ip mroute static
show ip pim bsr-router
show ip pim interface
show ip pim neighbor
show ip pim rp hash
Description
Configures the router to advertise itself to the
bootstrap router (BSR) as a PIM candidate
rendezvous point (RP) for a specific multicast
group range.
Administratively configures PIM sparse mode
for IP multicast routing.
Administratively configures PIM Source
Specific Multicast (SSM) range of addresses for
IP multicast routing.
Displays the system-wide multicast
information.
Displays the system-wide multicast
information.
Displays the multicast information for the
specified interface.
Displays a summary or all the details of the
multicast table.
Displays the multicast configuration settings of
entries in the multicast mroute table.
Displays the multicast configuration settings of
entries in the multicast mroute table.
Displays all the static routes configured in the
static mcast table.
Displays the bootstrap router (BSR)
information.
Displays PIM interface status parameters. If no
interface is specified, the command displays the
status parameters of all PIM-enabled interfaces.
Displays PIM neighbors discovered by PIMv2
Hello messages. If no interface is specified, the
command displays the neighbors discovered on
all PIM-enabled interfaces.
Displays the rendezvous point (RP) selected for
the specified group address.
Command Groups
a
Mode
IC
GC
GC
PE
PE
PE
PE
PE
PE
PE
PE
UE or
PE
UE or
PE
UE or
PE
142