Delete Snmp Group; Create Snmp - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28SC:admin#

94-15 delete snmp group

Description
This command is used to remove an SNMP group.
Format
delete snmp group <groupname 32>
Parameters
<groupname 32> - Enter the name of the group that will be deleted.
Restrictions
Only Administrator-level users can issue this command.
Example
To remove an SNMP group:
DGS-3620-28SC:admin#delete snmp group D_Link_group
Command: delete snmp group D_Link_group
Success.
DGS-3620-28SC:admin#

94-16 create snmp

Description
This command is used to create a recipient of an SNMP operation.
Format
create snmp [host <ipaddr> | v6host <ipv6addr>] [v1 | v2c | v3 [noauth_nopriv | auth_nopriv
| auth_priv]] <auth_string 32> {udp_port <udp_port_number 0-65535>}
Parameters
host - Specifies the IP address of the recipient for which the traps are targeted.
<ipaddr> - Enter the IP address of the recipient for which the traps are targeted.
v6host - Specifies the v6host IP address to which the trap packet will be sent.
<ipv6addr> - Enter the v6host IP address to which the trap packet will be sent.
v1 - Specifies the least secure of the possible security models.
v2c - Specifies the second least secure of the possible security models.
v3 - Specifies the most secure of the possible security models.
noauth_nopriv - Specifies to neither support packet authentication nor encrypting.
auth_nopriv - Specifies to support packet authentication.
1059