Class Cem - Cisco ASR 901 Command Reference Manual

class cem

class cem
To configure CEM interface parameters in a class that is applied to CEM interfaces together, use the
class cem command in global configuration mode. This command works in the same manner for CEM
interfaces as the pseudowire-class command does for xconnect.
Syntax Description class-name
Command Modes
Global configuration
Command History Release
15.1(2)SNG
Usage Guidelines The class cem command allows you to configure CEM interface parameters in a class that is applied to
CEM interfaces together. A class cem command includes the following configuration settings:
•
•
•
Note You can improve the performance of packet reordering on TDM/PWE connections by using the
increasing the size of the dejitter buffer using the dejitter-buffer parameter.
Examples The following example shows how to configure CEM interface parameters:
Router# config t
Router(config)# class cem mycemclass
Router(config-cem-class)# dejitter-buffer 10
Router(config-cem-class)# exit
Router(config)# interface cem 0/0
Router(config-if)# no ip address
Router(config-if)# cem 0
Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls
Router(config-if-cem-xconn)# cem class mycemclass
Router(config-if-cem)# exit
Router(config-if)# exit
Router(config)# exit
Cisco ASR 901 Aggregation Services Router Command Reference Guide
1-24
class cem class-name
The name of a CEM interface parameters class.
Modification
Support for this command was introduced on the Cisco ASR 901 router.
dejitter-buffer dejitter-in-ms
idle-pattern 8-bit-idle-pattern
payload-size payload-size-in-ms
Chapter 1 CLI Command Reference
OL-26031-07