Network-Clock Quality-Level - Cisco ASR 901 Command Reference Manual

network-clock quality-level

network-clock quality-level
To specify the QL value for line or external timing input or output, use the network-clock quality-level
command. Use the no form of the command to remove the configuration.
Syntax Description
interface-name
external
controller
value
Command Modes Interface configuration
Command History Release
15.1(2)SNG
Usage Guidelines The network-clock quality-level command specifies the QL value for line or external timing input or
output. The value is based on a global interworking Option.
•
•
•
This command is not supported for synchronous ethernet interfaces.
Examples This example specifies the QL value for external timing input:
Router(config-if)# network-clock quality-level rx QL-PRC external 4/0/0 e1 crc4
Cisco ASR 901 Aggregation Services Router Command Reference Guide
1-78
network-clock quality-level {tx | rx} <value> {interface <interface name> <slot/port> | external
<slot/card/port> | controller <slot/card/port>}
no network-clock quality-level
Specifies the interface.
Specifies an external slot/port/card.
Specifies the controller slot/port/card.
Value is based on options specified in usage guidelines section.
Modification
Support for this command was introduced on the Cisco ASR 901 router.
If Option 1 is configured, the available values are QL-PRC, QL-SSU-A, QL-SSU-B, QL-SEC, and
QL-DNU.
If Option 2 is configured with GEN 2, the available values are QL-PRS, QL-STU, QL-ST2,
QL-TNC, QL-ST3, QL-SMC, QL-ST4 and QL-DUS.
If option 2 is configured with GEN1, the available values are QL-PRS, QL-STU, QL-ST2, QL-SMC,
QL-ST4 and QL-DUS
Chapter 1 CLI Command Reference
OL-26031-07