Configuring Ancp Server Sender Name - Cisco ASR 9000 Series Configuration Manual

Configuring Access Node Control Protocol
SUMMARY STEPS
1. configure RP/0/RSP0/CPU0:router# configure RP/0/RSP0/CPU0:router(config)#
2. ancp RP/0/RSP0/CPU0:router(config)# ancp
3. end
4. or commit
5. show ancp summary [statistics][detail] RP/0/RSP0/CPU0:router# show ancp summary
DETAILED STEPS
Command or Action
Step 1 configure RP/0/RSP0/CPU0:router#
configure RP/0/RSP0/CPU0:router(config)#
Step 2 ancp RP/0/RSP0/CPU0:router(config)# ancp
Step 3 end
Step 4 or commit
Example:
RP/0/RSP0/CPU0:router(config-ancp)#
end
or
RP/0/RSP0/CPU0:router(config-ancp)#
commit
Step 5 show ancp summary [statistics][detail]
RP/0/RSP0/CPU0:router# show ancp
summary

Configuring ANCP Server Sender Name

The ANCP server sender name is used by the ANCP server in adjacency protocol messages to DSLAMs.
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide, Release 6.1.x
Purpose
Enters global configuration mode.
Enables ANCP.
Saves configuration changes.
• When you issue the end command, the system prompts you to
commit changes:
Uncommitted changes found, commit them before exiting
(yes/no/cancel)? [cancel]:
Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and returns the
router to EXEC mode.
Entering no exits the configuration session and returns the router
to EXEC mode without committing the configuration changes.
Entering cancel leaves the router in the current configuration session
without exiting or committing the configuration changes.
• Use the commit command to save the configuration changes to the
running configuration file and remain within the configuration
session.
(Optional) Displays ANCP summary and general configuration
information.
Configuring ANCP Server Sender Name
17