Loading Tabbed Sheets In Tray 1, 2, Or 3 - Konica Minolta 8050 Instruction Manual

Hide thumbs Also See for 8050:

Table of Contents

Loading Tabbed Sheets in Tray 1, 2, or 3

When TAB is displayed on the tray key of the Basic Screen, follow the procedure

below to supply the tray with tabbed sheets.

The tray paper type can be specified in the Key Operator setting. For details,

see p. 14-21 to p. 14-22.

The tab extension width must be 12.5 mm or less.

Withdraw tray 1, 2, or 3.

Open the paper feed roller.

Place the tabbed sheets on the tray as illustrated above.

Move the green levers (located at the front and the left side) to the

edge of the paper.

Close the paper feed roller, then push in the tray until it locks into

Example: 3 Tabbed sheets loaded in position for one finished set.

Example: 9 Tabbed sheets loaded in position for 3 finished sets.

Loading Paper (continued)

ONE FINISHED SET

Introduction

3 FINISHED SETS

Introduction

Introduction