Loading Tabbed Sheets In Tray 1, 2, Or 3 - Konica Minolta 7165 Instruction Manual

7155e02v1.fm 26 ページ ２００１年１１月２８日 水曜日 午前１０時３１分

Loading Tabbed Sheets in Tray 1, 2, or 3

When TAB is displayed on the tray key of the Basic Screen, follow the proce-
dure below to supply the tray with tabbed sheets.
Rear
Rear
1.
Withdraw tray 1, 2, or 3.
2.
Open the paper feed roller.
3.
Position the rear guide plate according to the size of the tabbed
sheets to be loaded.
4.
Place the tabbed sheets on the tray as illustrated above.
5.
While pressing the release knob, move the rear side guide plate
against the paper.
6.
Close the paper feed roller, then push in the tray until it locks into
place.
2-26
HINT
The tray paper type can be specified in the Key Operator setting. For
details, see p. 13-23 to p. 13-24.
Example: 3 Tabbed sheets loaded in position for one finished set.
Front
1st TAB
2nd TAB
3rd TAB
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
Front
1st TAB
2nd TAB
3rd TAB
Please Be Reminded!
The tab extension width should be 12.5mm or less.
HINT
See p. 2-29 for details on positioning the rear guide plate.
Loading Paper (continued)
Section 3
Management
Printed
Section 1
Introduction
side
ONE FINISHED SET
1st TAB
Section 3
Section 3
Management
Section 3
Management
Section 1
Management
Introduction
3rd TAB
2nd TAB
THREE FINISHED SETS
1st TAB
2nd TAB
3rd TAB
Section 1 Section 1
Introduction Introduction