Janome DigitizerPro Instruction Book page 74

3 If not already applied, select Candlewicking Run Line
from the Stitch Type list.
4 Adjust Size and Spacing as required.
OK
5 Click to apply.
Creating sculpture run outlines
Use Digitize > Sculpture Run to digitize sculpture
run outlines.
The Sculpture Run outline is use to simulate line
stitches used in quilting. It is a variation of multiple
run stitching, where each alternative
triple/multiple run stitch is replaced by a single run
stitch. Sculpture Run outline is recommended for
use only with MC11000. Recommended sewing
settings include:
Setting Recommended
Needle Red Tip needle #14
Needle thread Monofilament clear thread #60 (with
spool net)
Bobbin thread Rayon #60 (75d)
Bobbin holder Janome Bobbin holder for hand-look
stitching (#200-445-007) (preset with
lower tension)
Upper thread 7
tension
Stitch length 2
Speed 400 spm
JANOME Embroidery Software Instruction Book
Chapter 9 Outline & Fill Stitches
Note Results will vary depending on fabric and
other sewing conditions. In this case, it is
recommended to use Hand-looking Quilting Stitch
of MC11000 Special Edition. Test your design on a
small piece of fabric before stitching your project.
To create a sculpture run outline
1 Click the Sculpture Run icon and digitize a sculpture
run outline as you would a run stitch outline. See
Digitizing lines for details.
2 Double-click to access
3 If not already applied, select Sculpture Run Line from
the Stitch Type list.
4 Adjust Stitch Length as required.
object details.
72