Janome DigitizerPro Instruction Book page 209

Note The procedure for sending a single design to
machine is a little different to sending multiple
designs. See also Sending or receiving multiple
designs.
To send the design to machine
1 If you haven't already done so, select a MC10001 and
MC10000 V3.0 or higher machine model as your
current machine. See
memory cards for details.
2 Insert the ATA PC card into your JANOME
MemoryCraft machine if required.
3 Open or create the design you want to send.
4 Click the Send to Machine icon or select Machine >
Send Current Design.
If the machine is correctly linked, the Send Current
Design dialog opens.
Select destination
folder on sewing
machine
Click to change
name of output file
Click to send
design to
machine
Note The machine itself must be in PC-Link Mode in
order to receive the design.
5 Click Name to change the file name as required.
The JEF Name dialog opens.
6 Select a storage location on the sewing machine –
machine memory (built-in folder) or ATA PC card.
Supported machine models and
Enter new name
JANOME Embroidery Software Instruction Book
Chapter 26 Outputting to Machine
7 Click Send.
A confirmation box appears.
8 Click Start.
File transfer begins. The selected design is copied to
the specified location.
Note In the unlikely event that a file exceeds the limits
set, it will be split into two or more files. See
large files for details.
Sending or receiving multiple designs
You can simultaneously send more than one design
in JEF file format to your machine. You can also
retrieve all designs from machine memory for
editing and/or to store them on hard disk or other
location. Alternatively, delete all designs from
machine memory to free up space.
To send or receive multiple designs
1 If you haven't already done so, select a MC10001 and
MC10000 V3.0 or higher machine model as your
current machine. See
memory cards for details.
2 Insert the ATA PC card into your JANOME
MemoryCraft machine if required.
3 Select Machine > Send Designs, Receive and
Delete.
The Send Designs, Receive and Delete dialog
opens.
Select output option –
built-in memory or
ATA PC card
Splitting
Supported machine models and
207