Janome DigitizerPro Instruction Book page 113

Resequencing Objects
JANOME Embroidery Software lets you add to
designs quickly by duplicating and copying
existing objects. It also lets you combine designs
by inserting the contents of one file into another.
Stitching sequence usually occurs in the order in
which the design was digitized. However, you can
change this by a variety of methods.
This section describes how to combine objects
and designs by copying and pasting, duplicating,
and inserting techniques. It also describes how
to resequence objects by cut and paste, by color
or object.
Combining objects and designs
A design or design objects can be copied or cut and
placed on the Windows clipboard for temporary
storage. It can then be pasted any number of
times, within either the same or another design,
until replaced on the clipboard. You can also cut,
copy and paste lettering objects within and
between designs. When you insert one design in
another, the two
Color Charts
Inserting designs
Use Embroidery > Insert Design to combine two or more
designs.
JANOME Embroidery Software lets you insert one
design into another. The two (or more) designs can
then be saved as a combined design.
Combining and
To insert designs
1 Open the first design.
2 Travel to the point in the stitching sequence where you
3 Select Embroidery > Insert Design.
are merged.
Chapter 15
want to insert the second design. See
through designs for details.
You can insert a design between objects in the
sequence, or 'nest' the design within an object.
The Open dialog opens.
111
Traveling