Janome DigitizerPro Instruction Book page 202

JANOME Embroidery Software splits files at the last
color change before the limit is reached. If no color
change can be found before this, the operation is
rejected.
Note The ability to split a large design when
sending to JANOME MemoryCraft machine or
ATA PC Card is determined by the machine version
selected in Select Machine Model dialog. See
Selecting machine models
A maximum of 78 split files (and hence color
changes) is possible. It is very unlikely that a
single file will contain anywhere near 78 color
changes. Whether you send a design to machine or
ATA PC card, JANOME Embroidery Software names
the split JEF files automatically – e.g. MyFlower01,
MyFlower02, etc.
Split file
Note The ATA PC card connection menus and icon,
and the ability to split a design, are available in
both EasyDesign and EasyEdit.
Sending designs to machine
Use Standard > Send to Machine to send a design
to a machine for stitching.
for details.
JANOME Embroidery Software Instruction Book
Chapter 25 Reading and Writing Design Files
Depending on the machine model, the direct
machine connection option may be available to
you. This means you can send individual or
multiple design files directly to three possible
destinations:
Built-in: internal machine memory
ATA PC Card: PC memory card slot on machine
which can be used as an ATA PC card
reader/writer
USB Memory: USB stick attached to your
machine.
Try this! Alternatively, you can use an external
'Flash Memory' (ATA PC) reader/writer to write
designs in JEF format directly to card. See
to Flash Memory reader/writer
Sending the current design to machine
The procedure for sending a single design to
machine varies slightly with the machine model,
but the principle is the same. Whichever machine
you are using, the steps will involve one or all of
the following:
Select the machine model you intend to connect
to. See Selecting machine models
Insert the ATA PC card or USB stick into your
machine as required.
Open or create the design you want to send.
Click the Send to Machine icon or select
Machine > Send Current Design.
The particular dialog which opens will depend on
the selected machine model.
Select destination
folder on sewing
machine
Click to send
design to machine
Click to change
name of output file
Select a storage location on the sewing machine
– machine memory (built-in folder), ATA PC
card, or USB memory stick.
Start the file transfer.
Writing
for details.
for details.
200