Janome DigitizerPro Instruction Book page 153

Adjust Weave
Fill settings
Select Travel on
Edge
2 With Weave Fill selected as the stitch type, tick the
Travel on Edge checkbox.
Travel on Edge is automatically checked when Stitch
Spacing is greater than 0.80 mm or when Gradient Fill
is selected, but it can be unchecked at any time.
3 Adjust the Stitch Spacing setting as required.
The larger the value, the more open the spacing.
Spacing: 5 mm
4 Adjust other Weave Fill settings as required. See
Creating weave fills for details.
5 Click OK.
Travel runs and overlapping rows are removed and
consistent row spacing applied.
Digitizing appliqué
Automatically create all the stitching you need for
appliqué using the Appliqué tool. You can control
cover stitch settings, including stitch type – Satin
or E-Stitch – width, stitch spacing, as well as
offset. Up to three types of 'secondary objects' can
be generated:
Placement lines: These are the first appliqué
layer to be stitched. Placement lines are used to
position pre-cut appliqué patches on the
background material.
Cutting lines: Cutting lines form a guide when
trimming the appliqué patch in position.
Tackdown: This zigzag stitch is used to fix
appliqué patches to the background fabric
before cover stitching is applied.
Note A 'frame out' position is automatically set.
During stitchout, this shifts the hoop out from
under the needle, making it easier to place and
trim the appliqué shapes.
Creating appliqué objects
Use Appliqué to
Spacing: 3 mm
produce the stitching
you require for
appliqué
These are digitized in
the same way as
Parallel Fill objects. Up
to four layers of
stitching – placement
lines, cutting lines, tackdown and cover stitches –
can be generated for each appliqué object,
depending on current settings. See also
appliqué
To create appliqué objects
1 Insert an image for use as a digitizing backdrop as
2 Click the Appliqué icon.
3 Digitize the boundary of the appliqué, by marking
JANOME Embroidery Software Instruction Book
Chapter 19 Advanced Digitizing Techniques
Use Digitize > Appliqué to digitize appliqué
objects.
objects.
settings.
required. See Inserting images
reference points around the outline of the shape.
Click to create a corner point.
Right-click to create a curve point.
Placement line
Zigzag tackdown
Satin cover stitch
Adjusting
for details.
151