Janome DigitizerPro Instruction Book page 218

6 Change the number for ranking and click OK to close.
7 Tick the Standby option if you want to pre-load the
design on the machine ready for sewing.
8 Click Send button.
A confirmation box appears.
Note In the unlikely event that a file exceeds the limits
set, it will be split into two or more files. See
large files for details.
Sending multiple designs to machine
You can send more than one design in JEF file
format to your machine at a time.
Note If you attempt to send a design to machine
with a hoop not supported by the machine, you will
be prompted to select a different hoop. See
Supported hoop types
To send multiple designs to your machine
1 Select Machine > Send Designs.
The Send Designs dialog opens. The dialog is divided
in two sections – source (PC) and destination (sewing
machine).
Update
number
Splitting
for details.
JANOME Embroidery Software Instruction Book
Chapter 26 Outputting to Machine
Select source
folder on your
PC
Select files to
send
Use buttons to
navigate folders
of display file list
Note The machine itself must be in PC-Link Mode in
order to receive designs.
2 Browse to the folder containing the JEF files to be sent
to the machine using the shortcut icons in the PC list –
Designs, Desk Top and My Document.
The contents of the source location appear in the
display panel. Only files of JEF format are listed.
Names of designs are also placed in the File Name list.
Names of designs selected to be sent are shown in red.
Try this! The Style command button toggles the PC
file list box (and machine file list box) between Icons
View and Details View.
3 Select the file or files that you want to send in the PC
file list box.
If Icons View is on, a red tick appears beside a selected
design or if Details View is on, it is highlighted in red.
4 Select one of the machines connected to the PC via
USB displayed in Sewing Machine selection panel.
216