Janome DigitizerPro Instruction Book page 131

To reshape and spin the object around its center
point, use the side control point.
Try this! To scale a circle without changing it to an
oval, select it with the Select tool, and use the corner
selection handles to scale it.
Adjusting stitch angles
Stitch angle adjustments depend on the type of
object you are working with. With Parallel Fill
objects you can set a
object. You can do the same with Turning Angle
Fill objects. You can also adjust the stitch angle in
Turning Angle Fill and Parallel Fill objects using
the Reshape tool.
Note You cannot change the stitch angle of
Border objects as the stitches automatically turn
to follow the shape. You can, however, change the
stitch angle of Parallel Fill Circle objects by
moving the stitch entry point.
Drag top
control point
Drag side
control point
Scale using corner
selection handles
stitch angle for the entire
JANOME Embroidery Software Instruction Book
Chapter 17 Reshaping and Editing Objects
Adjusting Parallel Fill stitch angles by
object details
You can change the stitch angle
objects using Object Details.
To adjust Parallel Fill stitch angles by object
details
1 Select and double-click a Parallel Fill object.
The Object Details > Fill Stitch tab opens.
2 Select the Parallel Fill tab.
3 Enter the required stitch angle in the Fill Stitch Angle
field.
OK
4 Click .
Angle: 90°
Adjusting Parallel Fill stitch angle
on-screen
Click Edit > Reshape to display control points and
stitch angle lines in selected objects.
You can change the stitch angle
objects using the Reshape tool.
To adjust Parallel Fill stitch angles on-screen
1 Select a Parallel Fill object.
of Parallel Fill
Enter required
stitch angle
Angle: 0°
of Parallel Fill
129