Janome DigitizerPro Instruction Book page 139

Zigzag, Center Run + Zigzag, etc. This allows you
to apply dual underlays to design objects.
Note Any combination containing Center Run
cannot be used with Parallel Fill or Parallel Fill
Rectangle objects.
To change underlays
1 Select and double-click a fill object.
The Object Details dialog opens.
2 Select the Underlay tab.
Select
underlay
Select
underlay type
3 If not already checked, select the Underlay checkbox.
4 Make a selection from the Underlay Type list.
5 Click OK.
Adjusting Center Run and Edge Run
underlay settings
Center Run places a row of stitches along the
center of a column. It is used to stabilize narrow
columns – e.g. 2-3mm wide. Edge Run places
stitches around the edge of an object.
Note You cannot use Center Run with Parallel
Fill or Parallel Fill Rectangle objects.
JANOME Embroidery Software Instruction Book
Chapter 18 Object Details, Fabrics and Templates
To adjust Center Run or Edge Run underlay
settings
1 Select and double-click a fill object.
The Object Details dialog opens.
2 Select the Underlay tab.
Enter required
stitch length
3 Select Center Run or Edge Run from the Underlay
Type list.
4 Adjust Stitch Length setting as required:
5 Click OK.
Adjusting Zigzag underlay settings
Use Zigzag underlay stitching to support wide
columns. You can set stitch length properties for
Zigzag underlay. The stitch length is the length of
each zigzag stitch.
To adjust Zigzag underlay settings
1 Select and double-click a fill object.
The Object Details dialog opens.
2 Select the Underlay tab.
137
Stitch length:
2.0 mm
Stitch length:
4.0 mm