Janome DigitizerPro Instruction Book page 130

To add control points
1 Position the pointer where you want to add the control
point.
2 Click to add a control point.
Left-click to add a corner point.
Right-click to add a curve point.
3 Adjust the position of the control point by dragging it
along the outline as required.
Changing control points
Reshape object outlines by changing corner
points to curves, or vice versa.
Note You cannot change the end points of Turning
Angle Fill columns, or any control point in objects
created with the Parallel Fill Circle tool. See also
Reshaping circle objects.
To change control points
1 Select the control point.
Spacebar
2 Press .
Corner control point changes to curve, and vice versa.
Deleting control points
Delete unwanted control points
outline or to remove unwanted boundaries from
Parallel Fill objects.
Note You cannot delete the control points from
objects created with the Parallel Fill Circle tool.
See also Reshaping circle
To delete control points
1 Select the control point or points.
Delete
2 Press .
Left-click Right-click
control
to change an
objects.
JANOME Embroidery Software Instruction Book
Chapter 17 Reshaping and Editing Objects
Note If the object only has two control points (or two
pairs of control points as in the case of Turning Angle
Fill objects), deleting one deletes the whole object.
Reshaping circle objects
Use Edit > Reshape to reshape circle objects.
You can change Circle objects from circles to ovals
using the Reshape tool. Circle objects have two
reshape control points
and orientation of the object), a center point (used
to reposition it), and a stitch entry point. You
cannot add, change or delete control points in
these objects.
To reshape circle objects
1 Select a Parallel Fill Circle object.
2 Click the Reshape icon.
Entry point
90°
Stitch angle
Center point
Try this! To move a circle, click the control point in the
circle's center, and drag it to a new position.
3 Click a control point on the circle outline.
To reshape without changing the orientation, use the
top control point.
(used to change the radius
Control point
128