Janome DigitizerPro Instruction Book page 221

Select destination
folder on ATA PC
card
Click to write
design to card
Click to change
name of output file
Writing multiple designs to ATA PC card
The procedure for writing multiple designs to Flash
Memory reader/writer is essentially the same as
sending multiple design files to machine except
that you select External Media > Write Designs,
Read and Erase. See
machine for details.
Select source
folder on your PC
Select files to
write
Use buttons to
navigate folders of
display file list
Sending designs with
multi-position hoops
JANOME Embroidery Software supports both MA
and Giga hoops. These are two-position hoops
which expands the available sewing area of the
machine for which it is supplied.
Sending multiple designs to
JANOME Embroidery Software Instruction Book
Chapter 26 Outputting to Machine
Sending designs with an MA Hoop
Use Standard > Send to Machine to send the
current design to a machine for stitching.
JANOME Embroidery Software supports the MA
Hoop. This is a two-position hoop which expands
the available sewing area of the machine for which
it is supplied. In the list of available hoops, the MA
Hoop is identified as 'Hoop MA (200 x 280)'. The
two sewing fields are shown in red and blue. When
digitizing, each embroidery object must fit entirely
into one or other hoop position.
The behavior of the MA Hoop during loading and
editing of embroidery designs is exactly the same
as for a normal rectangular hoop of size 200 x 280.
The fact that there are two sewing fields has no
effect until you save the design or send it to a
machine. When sending to machine, in most cases
JANOME Embroidery Software will only create one
file as the two hoop positions are saved in a single
JEF file. However, if a return to hoop position 1 is
required, JANOME Embroidery Software will create
two (or on rare occasions, more) files.
To send a design with an MA Hoop
1 Open the design to send to machine.
The two sewing fields are shown in red and blue. When
digitizing, each embroidery object must fit entirely into
one or other hoop position.
Upper position
Lower position
MA Hoop
219