Janome DigitizerPro Instruction Book page 63

Use Digitize > Parallel Radial Fill to digitize
closed shapes with Radial fills.
Use the Parallel Fill tools to digitize large and
complex shapes generally with fixed rather than
turning stitch angles. Most shapes can be digitized
with these tools. See also
To create Parallel Fill objects
1 Click a Parallel Fill icon.
2 Digitize the boundary of the shape, by marking
reference points around the outline of the shape.
Click to enter corner points.
Right-click to enter curve points.
Try this! Follow the prompts in the status bar to help
you digitize. If you make a mistake, press Backspace
to delete the last reference point, then continue
digitizing.
3 Close the shape.
To close the shape with the same type of reference
point as the last you digitized – i.e. corner or curve –
simply press Enter.
To close the shape using a different type of reference
point, mark the last on top of the first and press
Enter.
Creating motif fills.
JANOME Embroidery Software Instruction Book
3
2
1
4
5
7
6
3
2
12
1
Last point is marked on top of first
13
with left button
Note Boundaries must not overlap.
4 Press Enter.
Note To adjust stitch angles
Adjusting stitch angles.
Digitizing circles
Use Digitize > Parallel Satin Fill: Circle to digitize
circles in Satin fill.
Use Digitize > Parallel Weave Fill: Circle to
digitize circles in Weave fill.
Use Digitize > Parallel Embossed Fill: Circle to
digitize circles in Embossed fill.
Use Digitize > Parallel Contour Fill: Circle to
digitize circles in Contour fill.
Use Digitize > Parallel Radial Fill: Circle to
digitize circles in Radial fill.
Digitize circles and ovals with a
few clicks. You can use any fill
stitch type with circles and ovals.
To digitize circles and ovals
1 Choose a Parallel Fill: Circle
method from the Digitize toolbar.
Chapter 8 Manual Digitizing
9
8
4
5
7
6
11
12
Object is closed
automatically
9
8
10
11
in Parallel Fill objects, see
61
10