Janome DigitizerPro Instruction Book page 206

Outputting to MC11000 machines
If you have selected MC11000 as your current
machine, the direct machine connection option is
available to you. This means you can send
individual or multiple design files directly to three
possible destinations:
built-in machine memory of your JANOME
MemoryCraft
ATA PC card attached to PC memory card slot on
your machine, or
a USB memory stick attached to your machine.
Try this! Alternatively, you can use an external
'Flash Memory' (ATA PC) reader/writer to write
designs in JEF format directly to card. See
to Flash Memory reader/writer
Sending the current design to machine
Use Standard > Send to Machine to send the
current design to a machine for stitching.
When sending the current design to machine, you
can send the design file directly to three possible
destinations:
Built-in machine memory of your JANOME
MemoryCraft
ATA PC card attached to PC memory card slot on
your machine, or
USB memory stick attached to your machine.
Note The procedure for sending a single design to
machine is a little different to sending multiple
designs. See also Sending or receiving multiple
designs.
To send the current design to machine
1 If you haven't already done so, select MC11000 as your
current machine. See
memory cards for details.
2 Insert the ATA PC card or USB stick into your JANOME
MemoryCraft machine if required.
Note Both ATA PC card and USB stick can be
attached at the same time.
3 Open or create the design you want to send.
Writing
for details.
Supported machine models and
JANOME Embroidery Software Instruction Book
Chapter 26 Outputting to Machine
4 Click the Send to Machine icon or select Machine >
Send Current Design.
If the machine is correctly linked, the Send Current
Design dialog opens.
Select destination
folder on sewing
machine
Click to send
design to machine
Click to change
name of output file
Note The machine itself must be in PC-Link Mode in
order to receive the design.
5 Click Name to change the file name as required.
The JEF Name dialog opens.
6 Select a storage location on the sewing machine –
machine memory (built-in folder), ATA PC card, or USB
memory stick.
Select storage
option
7 Click Send.
JANOME Embroidery Software checks whether the
selected hoop is supported by the destination machine.
If the hoop is an MA Hoop, this may mean that the
design must be split into more than one hoop
position, and possibly more than one JEF file. See
Sending designs with an MA Hoop
If the hoop is supported and is not an MA Hoop, the
selected design is copied to the specified location in
the current JEF format.
8 Click Start.
Enter new name
for details.
204