Janome DigitizerPro Instruction Book page 212

ATA PC Card: PC memory card slot on machine
which can be used as an ATA PC card reader/writer.
See Writing multiple designs to ATA PC card
details.
6 Click Name to change the file name as required.
The JEF Name dialog opens.
7 Click OK.
A progress bar shows the progress of the file transfer.
Try this! You can cancel the file transfer by closing the
Send Designs dialog.
Sending multiple designs to machine
You can send multiple design files in JEF file format
to your machine at a time. There are two possible
destinations:
built-in machine memory of your JANOME
MemoryCraft
ATA PC card attached to PC memory card slot on
your machine.
To send multiple designs to machine
1 If you haven't already done so, select a MC10000
V2.21 machine model as your current machine. See
Supported machine models and memory cards
details.
2 Insert the ATA PC card into your JANOME
MemoryCraft machine if required.
3 Select Machine > Send Designs.
The Select Designs dialog opens.
for
Enter new name
for
JANOME Embroidery Software Instruction Book
Chapter 26 Outputting to Machine
4 Select a source folder from the Look In list.
5 Select a file or files from the list.
The preview panel displays an image of the
last-selected design.
6 Click Add to add to the list of files to send.
If you add a wrong file, click Clear to remove it from the
list. Select any design by name to preview.
7 Select a destination for the files to be sent:
Built-in: internal machine memory
ATA PC Card: PC memory card slot on machine
which can be used as an ATA PC card reader/writer.
8 Click Send.
The Send Designs dialog opens.
9 Select to send the design to either the built-in memory
or PC card slot.
10 Click Start.
A progress bar shows the progress of the file transfer.
Try this! You can cancel the file transfer by closing the
Send Designs dialog.
210
Click to
add
Select
source
folder
Select
destination