Janome DigitizerPro Instruction Book page 155

E-Stitch Width: 2.5 mm
Satin Width: 2.5 mm
7 Select an appliqué 'style':
Pre-cut: Placement lines, tackdown and cover
stitches are generated.
Trim in Place: In addition, a cutting line is generated.
Note If you choose to generate a cutting line, place the
fabric patch after the placement line has been stitched,
then trim in position after the cutting line has been
stitched.
8 Use the Inside and Outside percentage settings to
adjust the cover stitch and tackdown offset.
E-Stitch Width: 1.5 mm
Satin Width: 1.0 mm
Placement line
Zigzag tackdown
Satin cover stitch
JANOME Embroidery Software Instruction Book
Chapter 19 Advanced Digitizing Techniques
Offset: inside
For Satin stitch, the cover stitch and tackdown are
offset against the placement line using the slider. The
offset can be inside or outside the appliqué boundary.
For Blanket stitch, the offset is always 100% inside.
9 Click OK.
Offset: none Offset: outside
153