Janome DigitizerPro Instruction Book page 211

Select destination
folder on sewing
machine
Click to change
name of output file
Click to write
design to card
Writing multiple designs to ATA PC card
The procedure for writing a single design to Flash
Memory reader/writer is essentially the same as
sending multiple design files to machine except
that you select External Media > Write Designs,
Read and Erase. See
multiple designs for details.
Select source
folder
Select
designs to
send
Click to select
all designs
Outputting to MC10000 V2.21
machines
If you have selected MC10000 V2.21 as your
current machine, the direct machine connection
option is available to you. This means you can send
individual or multiple design files directly to two
possible destinations:
built-in machine memory of your JANOME
MemoryCraft
ATA PC card attached to PC memory card slot on
your machine.
Sending or receiving
JANOME Embroidery Software Instruction Book
Chapter 26 Outputting to Machine
Try this! Alternatively, you can use an external
'Flash Memory' (ATA PC) reader/writer to write
designs in JEF format directly to card. See
to Flash Memory reader/writer
Sending the current design to machine
Use Standard > Send to Machine to send the
current design to a machine for stitching.
When sending the current design to machine, you
can send the design file directly to two possible
destinations:
built-in machine memory of your JANOME
MemoryCraft
ATA PC card attached to PC memory card slot on
your machine.
Note The procedure for sending a single design to
machine is a little different to sending multiple
designs. See also Sending multiple designs to
machine.
To send the current design to machine
1 If you haven't already done so, select a MC10000
V2.21 machine model as your current machine. See
Supported machine models and memory cards
details.
2 Insert the ATA PC card into your JANOME
MemoryCraft machine if required.
3 Open or create the design you want to send.
4 Click the Send to Machine icon or select Machine >
Send Current Design.
The Send Designs dialog opens.
5 Select a destination for the files to be sent:
Built-in: internal machine memory
Writing
for details.
for
209