Janome DigitizerPro Instruction Book page 177

Try this! You can also insert a color change
between two letters by keying a caret (^) symbol.
Subsequent letters default to the next color in the
palette. See Adding lettering to embroidery
designs for details.
To recolor letters on-screen
1 Click the lettering with the Select tool selected.
2 Click the Lettering icon then click within the lettering
object.
3 Select a letter (or letters) by dragging the cursor over
the letter.
4 Click a color on the Color
Enter
5 Press .
6 Repeat to recolor other letters.
Adjusting orientations
Lettering orientation can be adjusted on-screen
after it has been placed in your design by means of
the Reshape tool.
Reshaping horizontal orientations
Use Edit > Reshape to reshape lettering
orientations.
Drag cursor
over letter to
select
Chart.
JANOME Embroidery Software Instruction Book
Chapter 22 Editing Embroidery Lettering
Reshape straight orientations to place them on an
angle. See also Setting lettering
To reshape a horizontal orientation
1 Select the lettering object.
2 Click the Reshape icon to display control points.
Baseline control points
Try this! The large diamond and cross represent
stitching start and end points. You may need to move
them to access baseline
reposition themselves in the new entry and exit points
based on the changes you make to the baseline.
3 To change the angle, click and drag one of the large
solid squares.
Drag up or down to change the
baseline angle
4 To change the letter spacing click and drag the open
triangle control point.
Note With Fixed Line orientation, lettering is not
increased if the baseline is longer than needed to fit the
specified lettering. See
orientations for details.
Esc
5 Press to complete.
Reshaping circular orientations
Use Edit > Reshape to reshape lettering
orientations.
orientations.
control points. They will
Drag to change
spacing evenly
Creating fixed-length horizontal
175