Janome DigitizerPro Instruction Book page 214

2 Insert the ATA PC card into your JANOME
MemoryCraft machine if required.
3 Select Machine > Delete Designs.
When all designs are retrieved from the machine, the
Delete Designs dialog opens. This allows you to
delete one, many, or all designs.
Note By default the PC-Link built-in memory is
selected. For other options, see
from machine.
4 Select a location for the files to be deleted from:
built-in machine memory of your JANOME
MemoryCraft
ATA PC card attached to PC memory card slot on
your machine.
5 Select a file or files to delete.
A checkmark appears beside each selected design.
Try this! Click Select All Designs to select all designs
in the source folder.
6 Click Delete.
A confirmation box appears. The selected designs are
deleted from the specified location.
Writing to Flash Memory reader/writer
Use Standard > Write to Card to send a design to
an ATA PC card.
If you are using an external 'Flash Memory'
(ATA PC) reader/writer, you can write designs in
JEF format directly to card. Make sure the
reader/writer is securely plugged into the USB port
of your PC. If you are writing to a card intended for
use with an MC10000 V2.21 machine model, make
sure this is selected as your current machine. After
writing your design, simply insert the card into the
ATA PC card slot on your machine and read in the
design. See Supported machine models and
memory cards for details.
Writing a design to ATA PC card
The procedure for writing a single design to Flash
Memory reader/writer is essentially the same as
sending a single design file to machine except that
you click the Write to Card icon or select
External Media > Write a Design. See
the current design to machine
Writing multiple designs to ATA PC card
The procedure for writing multiple design files to
Flash Memory reader/writer is essentially the same
Receiving designs
as sending multiple design to machine except that
you select External Media > Write Designs,
Read and Erase. See
machine
JANOME Embroidery Software Instruction Book
Chapter 26 Outputting to Machine
Sending multiple designs to
for details.
Sending
for details.
212