Janome DigitizerPro Instruction Book page 205

203
Chapter 26
Outputting to Machine
Direct Connect for new and some older
machines, saving to ATA PC card and
saving JEF files to hard and floppy disk,
are all possible in both EasyDesign and
EasyEdit.
JANOME Embroidery Software supports
various sets of machine model: MC11000
machines, MC1000* machines, MC10000
V2.21 machines, MC9700/9500 machines,
MC350E/300E/200E machines, and MB-4
machine machines. The first two sets of
machine support direct connection,
although menu options change depending
on the chosen machine set. MC10000 V2.2
or earlier machines must be upgraded to
Version 2.21. The MC9700, MC9500,
MC300E, and MC350E machines do not
support direct connection but they do read
ATA PC cards and USB memory sticks.
MC200E machines support USB memory
sticks.
Direct Connection to the MB-4 machine is only available in JANOME
DigitizerPro.
This section describes how to output designs directly to supported machine
models.