Janome DigitizerPro Instruction Book page 150

the Object Details dialog. Change these settings
before or after applying the effect. See
Feather Edge settings
To apply Feather Edge
Click the Feather Edge icon.
The effect is applied to new or selected objects, based
on the current Feather Edge settings.
Click Feather Edge again to remove the effect.
Adjusting Feather Edge settings
Click Edit > Feather Edge to apply the effect to
new or selected objects.
Adjust the Feather Edge settings to change the
amount of feathering, the side of the object to
which the effect is applied and the margin in which
the stitches should fall.
Range
To adjust Feather Edge settings
1 Select and double-click the object.
The Object Details dialog opens.
2 Select the Feathering tab.
Adjusting
for details.
JANOME Embroidery Software Instruction Book
Chapter 19 Advanced Digitizing Techniques
3 Select the Feathered checkbox.
4 Enter a Maximum Width for the feathering, this is the
margin in which the stitches will fall.
Max. Width: 0.5mm
5 Use the Raggedness slider to indicate the required
degree of texture:
left for a smooth texture
right for a rough texture.
Raggedness: Low: less
variation in stitch length
6 Select the Feathered Side checkbox you require: left
or right or both.
7 Click OK.
Max. Width: 3.0mm
Raggedness: High: more
variation in stitch length
148