Janome DigitizerPro Instruction Book page 62

Low density
Digitizing columns of varying width
Use Digitize > Turning Angle Satin Fill to create
Satin fill columns of varying width and stitch
angle.
Use Digitize > Turning Angle Weave Fill to create
Weave fill columns of varying width and stitch
angle.
Use Digitize > Turning Angle Embossed Fill to
create Embossed fill columns of varying width
and stitch angle.
Use Digitize > Turning Angle Contour Fill to
create Contour fill columns of varying width and
stitch angle.
Use Digitize > Turning Angle Radial Fill to create
Radial fill columns of varying width and stitch
angle.
Use the Turning Angle Fill
tools to digitize columns of
varying width with turning
stitches. Digitized pairs of
reference points define the
outline, while lines connecting
the pairs define the stitch
angles.
To digitize columns of varying width
1 Click a Turning Angle Fill icon.
2 Digitize the shape by marking reference points on
alternate sides of the column.
Click to enter corner points.
Right-click to enter curve points.
Mark a pair of points wherever the outline changes, and
wherever you want the stitch angle to change.
High density
3 When you have finished digitizing the line, either:
Digitizing complex shapes with
fixed stitch angles
JANOME Embroidery Software Instruction Book
Stitches change their angle
gradually
Note The control points in a pair do not have to be the
same type. For example, one can be a corner point, the
other a curve.
Try this! If you make a mistake, press Backspace to
delete the last reference point, then continue digitizing.
Press Enter to keep the last stitch and place the exit
point at the last reference point you digitized, or
Press Spacebar to omit the last stitch and place the
exit point on the opposite side of the column.
Try this! If you are joining two columns, omit the last
stitch on the first column so that the exit point is close
to the entry point of the next column.
Use Digitize > Parallel Satin Fill to digitize closed
shapes with Satin fills.
Use Digitize > Parallel Weave Fill to digitize
closed shapes with Weave fills.
Use Digitize > Parallel Embossed Fill to digitize
closed shapes with Embossed fills.
Use Digitize > Parallel Motif Fill to digitize closed
shapes with Motif fills.
Use Digitize > Parallel Contour Fill to digitize
closed shapes with Contour fills.
Chapter 8 Manual Digitizing
Stitches remain parallel between
parallel stitch angles
60