Janome DigitizerPro Instruction Book page 210

Select source
folder
Select
designs to
send
Click to select
all designs
4 Select a source folder from the PC list.
Only JEF files are displayed.
5 Select the file or files that you want to send in the
viewing panel.
The preview panel displays an image of the last
selected design.
Try this! Click Select All Designs to select all designs
in the source folder.
6 Select a storage location on the sewing machine –
machine memory (built-in folder) or ATA PC card.
7 Click Send.
A confirmation box appears.
8 Click Start.
File transfer begins and selected designs are copied to
the selected location.
Note In the unlikely event that a file exceeds the limits
set, it will be split into two or more files. See
large files for details.
9 Select any files you want to receive or delete from the
destination folder.
Try this! Click Select All Designs to select all designs
in the source folder.
Select output option –
built-in memory or
ATA PC card
Splitting
JANOME Embroidery Software Instruction Book
Chapter 26 Outputting to Machine
The preview panel displays an image of the last
selected design.
Click to receive
10 Choose from the available options as required:
Click Receive to copy files from the machine to the
current location folder on your PC.
Click Delete button to remove selected files from
your machine storage location.
Writing to Flash Memory reader/writer
Use Standard > Write to Card to send a design to
an ATA PC card.
If you are using an external 'Flash Memory'
(ATA PC) reader/writer, you can write designs in
JEF format directly to card. Make sure the
reader/writer is securely plugged into the USB port
of your PC. If you are writing to a card intended for
use with an MC10001, MC10000 V3.0, or higher
machine model, make sure this is selected as your
current machine. After writing your design, simply
insert the card into the ATA PC card slot on your
machine and read in the design. See
machine models and memory cards
Writing a design to ATA PC card
The procedure for writing a single design to Flash
Memory reader/writer is essentially the same as
sending a single design file to machine except that
you click the Write to Card icon or select
External Media > Write a Design. See
the current design to machine
Click to delete
Supported
for details.
Sending
for details.
208