Janome DigitizerPro Instruction Book page 215

Outputting to MC9700 or lower
machines
If you have selected an MC9700 or lower machine
model – MC9500, MC350E, or MC300E – as your
current machine, the direct machine connection
option is not available to you. These machines
have a PC memory card slot which is used read
designs into the machine. Using an external 'Flash
Memory' (ATA PC) reader/writer, you can write
designs in JEF format directly to card. Then simply
insert the card into the ATA PC card slot on your
machine, and read in the design. See
machine models and memory cards
Note Some machines can read USB memory
sticks as well as ATA PC cards. The procedure for
writing to them is the same. The MC200E machine
only supports USB memory sticks. The procedure
is slightly different for this model. See
to MC200E machines for details.
Writing a design to ATA PC card
Use Standard > Write to Card to send a design to
an ATA PC card.
If you have selected an MC9700 or lower machine
model as your current machine, the direct machine
connection option is not available to you. This
means you need to use an external 'Flash Memory'
(ATA PC) reader/writer to write designs in JEF
format directly to card.
To write a design to ATA PC card
1 If you haven't already done so, select an MC9700 or
lower machine model as your current machine. See
Supported machine models and memory cards
details.
2 Make sure the reader/writer is securely plugged into
the USB port of your PC.
3 Open or create the design you want to send.
4 Click the Write to Card icon or select External
Media > Write a Design.
If the machine is correctly linked, the Write a Design
dialog opens.
change name
of output file
Click to write
design to card
Supported
for details.
Note The machine itself must be in PC-Link Mode in
order to receive the design.
5 Click Name to change the file name as required.
The JEF Name dialog opens.
Outputting
6 Click Write.
A confirmation box appears.
7 Click Start.
File transfer begins. The selected design is copied to
the ATA PC card.
Note In the unlikely event that a file exceeds the limits
set, it will be split into two or more files. See
large files
Writing or reading multiple designs
If you have selected an MC9700 or lower machine
for
model as your current machine, the direct machine
connection option is not available to you. This
means you need to use an external 'Flash Memory'
(ATA PC) reader/writer to write designs in JEF
format directly to card.
To write or read multiple designs
1 If you haven't already done so, select a MC9700 or
lower machine model as your current machine. See
Supported machine models and memory cards
details.
JANOME Embroidery Software Instruction Book
Chapter 26 Outputting to Machine
Click to
for details.
Enter new name
Splitting
for
213