Transmission End Grankshaft Seal Installation - In Car - Honda EP3 Service Manual

Engine Block
Oil Pan Installation (cont'dl
6 . l f t h e e n g i n e i s s t i l l i n t h e v e h i c l e , i n s t a l l t h e
subframe,
- 1 I n s t a l l t h e s u b f r a m e . A l i g n t h e r e f e r e n c e l i n e s
on the subframe with the bolt head center, then
tighten the bolts (see step 5 on page 5-10).
-2 Tighten the front mounting bolt (see step 6 on
p a g e 5 - 1 0 ) .
-3 Tighten the rear mount mounting bolts (see
s t e p 7 o n p a g e 5 - 1 1 ) .
-4 Connect the suspension lower arm ball joints
(see step 6 on page 18-19).
7. After assembly, wait at least 30 minutes before
f i l l i n g t h e e n g i n e w i t h o i l .
7-28
v
Transmission End Grankshaft Seal
Installation - In Car
Special Tools Required
. Driver 07749-0010000
. Oil seal driver attach ment 96 07ZAD-PNAA100
' 1 .
D r y t h e c r a n k s h a f t o i l s e a l h o u s i n g .
2. Use the special tools to drive a new oil seal
squarely into the block to the specified installed
h e i g h t .
07749-0010000
a n d o i l s e a l ( B ) .
Oil Seal Installed Height:
5.5 6.5 mm 10.22-0.26 in.l
5.5 6.5 mm
l0.22- O.26 in .l
I
/$rRfr4T
tr*W(r
-]t fl\
OTZAD.PNAAlOO
Measure the distance between the crankshaft (A)
a