Table of Contents
Advertisement
Field Name
Parity Error Response
Wait Cycle Control
SERR# Enable
Fast Back-to-Back
Enable
Reserved
PCI Command register
Field Name
Reserved
MSI Mapping Capability
66 MHz Capable
UDF Supported
Fast Back-to-Back
Capable
Data Parity Error
Detected
DEVSEL Timing
Signaled Target Abort
Received Target Abort
Received Master Abort
Signaled System Error
Detected Parity Error
PCI device status register
©2008 Advanced Micro Devices, Inc.
AMD SB600 Register Reference Manual
Command- RW - 16 bits - [PCI_Reg: 04h]
Bits
Default
6
0b
This bit controls the device's response to parity errors. When
the bit is set, the device must take its normal action when a
parity error is detected. When the bit is 0, the device must
ignore any parity errors that it detects and continue normal
operation.
7
0b
This bit is used to control whether or not a device does
address/data stepping. This module does not use address
stepping. [Read-only]
8
0b
This bit is an enable bit for SERR# driver. A value of 0
disables the SERR# and a value of 1 enables it.
9
0b
This bit indicates whether device is fast back-to-back capable.
ACPI/SMbus does not support this function and so this bit is
always 0. [Read-only]
15:10
00h
STATUS- RW - 16 bits - [PCI_Reg: 06h]
Bits
Default
3:0
4
1/0b
[Read-only] This bit indicates whether the device can support
MSI mapping. For K8 system this device is MSI mapping
capable so default value is 1; for P4 system this device does
not support MSI mapping so default value is 0.
5
1b
This bit indicates whether the device can support 66 MHz.
This device is 66 MHz capable. [Read-only]
6
0b
This bit indicates whether the device supports user definable
feature. This module does not support this feature and so it is
always 0. [Read-only]
7
0b
This bit indicates whether the device is capable of fast back-to-
back cycles. This module does not support this feature and so
it is always 0. [Read-only]
8
0b
Set to 1 if the Parity Error Response bit is set, and the module
has detected PERR# asserted while acting as a PCI master
(regardless PERR# was driven by this module).
10:9
01b
These bits encode the timing of DEVSEL#. This module will
always respond in medium timing and so these bits are always
11.
11
0b
This bit is set by a slave device whenever it terminates a cycle
with a Target-Abort.
12
0b
This bit is set by a master device whenever its transaction is
terminated with a Target-Abort.
13
0b
This bit is set by a slave device whenever it terminates its
transaction with Master-Abort.
14
0b
This bit is set by device whenever the device asserts SERR#.
15
0b
This bit is set by device whenever it detects a parity error,
even if parity error handling is disabled.
Description
Description
SMBus Module and ACPI Block (Device 20, Function 0)
Proprietary
Page 99
Advertisement
Table of Contents
