Table of Contents
Advertisement
USBCMD – RW - 32 bits - [EOR_Reg : EHCI_EOR + 00h]
Field Name
Bits
Asynchronous
9:8
Schedule Park
Mode Count
(Optional)
Reserved
10
Asynchronous
11
Schedule Park
Mode Enable
(Optional)
Reserved
15:12
Interrupt
23:16
Threshold
Control
Reserved
31:24
Field Name
Bits
USBINT
0
USBERRINT
1
©2008 Advanced Micro Devices, Inc.
AMD SB600 Register Reference Manual
Default
00b
If the Asynchronous Park Capability bit in the HCCPARAMS register is a
one, then this field defaults to 3h and is R/W. Otherwise it defaults to
zero and is RO. It contains a count of the number of successive
transactions the host controller is allowed to execute from a high-speed
queue head on the Asynchronous schedule before continuing traversal
of the Asynchronous schedule. Valid values are 1h to 3h. Software
must not write a zero to this bit when Park Mode Enable is a one as this
will result in undefined behavior.
[Read/Write or Read-only]
This bit is reserved and should be set to Zero.
0b
[Read-only]
If the Asynchronous Park Capability bit in the HCCPARAMS register is a
one, then this bit defaults to a 1h and is R/W. Otherwise the bit must be
a zero and is RO. Software uses this bit to enable or disable Park mode.
When this bit is one, Park mode is enabled. When this bit is a zero, Park
mode is disabled.
This bit is reserved and should be set to Zero.
08h
This field is used by system software to select the maximum rate at
which the host controller will issue interrupts. The only valid values are
defined below. If software writes an invalid value to this register, the
results are undefined.
00h = Reserved
01h = 1 micro-frame
02h = 2 micro-frames
04h = 4 micro-frames
08h = 8 micro-frames (default, equates to 1 ms)
10h = 16 micro-frames (2 ms)
20h = 32 micro-frames (4 ms)
40h = 64 micro-frames (8 ms)
Any other value in this register yields undefined results. Software
modifications to this bit while HCHalted bit is equal to zero results in
undefined behavior.
These bits are reserved and should be set to Zeros.
USBSTS - RW - 32 bits - [EOR_Reg : EHCI_EOR + 04h]
Default
0b
USB Interrupt. The Host Controller sets this bit to 1 on the completion of
a USB transaction, which results in the retirement of a Transfer Descriptor
that had its IOC bit set. The Host Controller also sets this bit to 1 when a
short packet is detected (actual number of bytes received was less than
the expected number of bytes).
0b
USB Error Interrupt . The Host Controller sets this bit to 1 when
completion of a USB transaction results in an error condition (e.g., error
counter underflow). If the TD on which the error interrupt occurred also
had its IOC bit set, both this bit and USBINT bit are set.
Description
Description
OCHI USB 1.1 and EHCI USB 2.0 Controllers
Proprietary
Page 84
Advertisement
Table of Contents
