Initial Configuration Overview - Enterasys C5G124-24 Configuration Manual

Fixed switch platforms
Hide thumbs Also See for C5G124-24:
Table of Contents

Advertisement

Table 4-2 Default Settings for Router Operation (continued)
Feature
Hello interval (OSPF)
ICMP
IP-directed broadcasts
IP forward-protocol
IP interfaces
IRDP
MD5 authentication (OSPF)
MTU size
OSPF
OSPF cost
OSPF network
OSPF priority
Passive interfaces (RIP)
Proxy ARP
Receive interfaces (RIP)
Retransmit delay (OSPF)
Retransmit interval (OSPF)
RIP receive version
RIP send version
RIP offset
SNMP
Split horizon
Stub area (OSPF)
Timers (OSPF)
Transmit delay (OSPF)
VRRP

Initial Configuration Overview

To configure your stackable or standalone switch for the first time, see
Switch for the First
switch via the console port and an Ethernet cable to set the switch's IP address and to download
the latest firmware. The procedures in this chapter assume an in-band connection over the
network to the switch using Telnet or SSH to establish a CLI session on the switch.
Default Setting
Set to 10 seconds for broadcast and point-to-point networks. Set
to 30 seconds for non-broadcast networks.
Enabled for echo-reply and mask-reply modes.
Disabled.
Enabled with no port specified.
Disabled with no IP addresses specified.
Disabled on all interfaces. When enabled, maximum
advertisement interval is set to 600 seconds, minimum
advertisement interval is set to 450 seconds, holdtime is set to
1800 seconds, and address preference is set to 0.
Disabled with no password set.
Set to 1500 bytes on all interfaces.
Disabled.
Set to 10 for all interfaces.
None configured.
Set to 1.
None configured.
Enabled on all interfaces.
Enabled on all interfaces.
Set to 1 second.
Set to 5 seconds.
Set to accept both version 1 and version 2.
Set to version 1.
No value applied.
Enabled.
Enabled for RIP packets without poison reverse.
None configured.
SPF delay set to 5 seconds. SPF holdtime set to 10 seconds.
Set to 1 second.
Disabled.
Time. That chapter includes information about how to directly connect to the

Initial Configuration Overview

Chapter
1,
Setting Up a
Fixed Switch Configuration Guide 4-5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents