Reviewing Port Status; Purpose; Commands - Enterasys D-Series Cli Reference Manual

Example
This example shows how to configure port ge.2.1 in the D2G124‐12 to operate with a 100BASE‐FX
transceiver installed. First, the port status is shown as operating as a 1000BASE‐SX port. After the
1‐Gigabit transceiver is replaced with the a 100 Mbps transceiver, the port is configured
appropriately and the new settings are verified.
D2(su)->show port advertise ge.2.1
ge.2.1
-------------------------------------------------
10BASE-T
10BASE-TFD
100BASE-TX
100BASE-TXFD
1000BASE-T
1000BASE-TFD
pause
D2(su)->show port status ge.2.1
Port
--------- ------------ ------- ------- --------- ------- ------------
ge.2.1
D2(su)->set port negotiation ge.2.1 disable
D2(su)->set port advertise ge.2.1 100txfd
D2(su)->set port speed ge.2.1 100
D2(su)->set port duplex ge.2.1 full
D2(su)->show port status ge.2.1
Port
--------- ------------ ------- ------- --------- ------- ------------
ge.2.1
For more information, refer to the commands in this chapter and to your D‐Series hardware
installation documentation.

Reviewing Port Status

Purpose

To display operating status, duplex mode, speed, port type, and statistical information about
traffic received and transmitted through one or all switch ports on the device.

Commands

For information about...
show port
show port status
show port counters
capability advertised
no no
no no
no no
yes no
no no
yes yes
yes yes
Alias Oper
(truncated) Status
Down
Alias Oper
(truncated) Status
Down
remote
no
no
no
no
no
no
no
Admin Speed
Status (bps) Duplex
Up N/A N/A
Admin Speed
Status (bps) Duplex
Up 100.0M full
Reviewing Port Status
Type
1000BASE-SX
Type
100BASE-FX
Refer to page...
6-4
6-4
6-5
Enterasys D-Series CLI Reference 6-3