Kdswhu#46#±#,Qvwdoolqj#Dqg#Frqqhfwlqj; Furvv0Frqqhfw#Whuplqdov#Wr#Fdelqhwv#1#1#1#1#1#1#1#1#1#1#1; Installing The Bix Cross-Connect Terminal; Installing The Reichle Masari Cross-Connect Terminal (Germany) - Nortel Meridian 1 option 11C Planning And Installation Manual

&KDSWHU#46#±#,QVWDOOLQJ#DQG#FRQQHFWLQJ
FURVV0FRQQHFW#WHUPLQDOV#WR#FDELQHWV
*HQHUDO#LQIRUPDWLRQ
This chapter describes how to install and connect a cross-connect terminal to
an Option 11C system, using either:
• a BIX cross-connect terminal
• a Reichle Masari cross-connect terminal, or
• a Krone Test Jack Frame
Note: Although the use of the BIX system is not mandatory, it is the
recommended choice.
This chapter contains the following procedures:
• Procedure 15 "Installing the BIX cross-connect terminal" on page 149
• Procedure 16 "Installing the Reichle Masari cross-connect terminal" on
page 151
• Procedure 17 "Installing the KroneTest Jack Frame" on page 153
• Procedure 18 "Connecting the cables" on page 155
Information about the BIX cross-connect system is found in the following
publications:
• BIX In-Building Cross-Connect System Material Description
(NTP 631-4511-100)
• BIX In-Building Cross-Connect System Planning (NTP 631-4511-150)
• BIX In-Building Cross-Connect System Material Installation and
Servicing (NTP 631-4511-200)
2SWLRQ#44& 3ODQQLQJ#DQG#,QVWDOODWLRQ#*XLGH
3DJH#47:#RI#699