Removing And Installing The Brake Pressure Sender - Skoda Kodiaq 2017 Workshop Manual

Kodiaq 2017 ➤ , Kodiaq 2019 ➤
Brake systems - Edition 11.2018
4.2.2 Summary of components - speed sensors on rear axle, vehicles with four-
wheel drive
Note
Replace bolts / nuts that are tightened at an angle of rotation, as well as replacement components after removal.
1 - Rear speed sensor - G44- /
-G46-
❑ Assignment ⇒ Electron‐
ic Catalogue of Original
Parts
❑ clean the inner surface
of the hole before insert‐
ing the sensor and
brush over with a hot
bolt paste - G 052 112
A3- .
❑ Removing and installing
⇒ "4.7 Removing and in‐
stalling the rear speed
sensors G44 / G46 ",
page 43
2 - Screw
❑ 8 Nm
3 - Drive shaft
4 - Wheel hub with wheel bear‐
ing
❑ Sensor ring for ABS is
built into the wheel hub
4.3 Removing and installing the brake pres‐
sure sender
The brake pressure sender sensor 1 - G201- is integrated in the
ABS hydraulic unit - N55- and cannot be removed separately.
If brake pressure sender 1 - G201- is damaged, the ABS control
unit - J104- with the ABS hydraulic unit - N55- must be fully re‐
placed
⇒ "3.2 Removing and installing ABS control unit J104 / ABS hy‐
draulic unit N55 ", page 19
42
Rep. gr.45 - Anti-lock brake system
.