Removing And Replacing Max5 Tier 1 Crus; Removing The Max5 Bezel; Replacing The Max5 Bezel - IBM x3690 X5 Service Manual

Hide thumbs Also See for x3690 X5:

Table of Contents

Removing and replacing MAX5 Tier 1 CRUs

Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at

your request, you will be charged for the installation.

The illustrations in this document might differ slightly from your hardware.

To remove the MAX5 bezel, complete the following steps:

1. Read the safety information and installation guidelines, see "Safety" on page vii

2. Press in on the release tabs on both end of the bezel and pull it off of the

To replace the MAX5 bezel, complete the following steps:

1. Read the safety information that begins on page "Safety" on page vii and

2. Align the bezel alignment tabs with the chassis and press the bezel onto the

System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide

and "Installation guidelines" on page 261.

"Installation guidelines" on page 261.

chassis until it snaps into place.