IBM x3690 X5 Service Manual page 424

v User Security
v Save Settings
v Restore Settings
v Load Default Settings
v Exit Setup
406
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide
The system-event log contains POST and system management interrupt (SMI)
events and all events that are generated by the baseboard management
controller that is embedded in the integrated management module (IMM).
Important: If the system-error LED on the front of the server is lit but there are
no other error indications, clear the system-event log. Also, after you complete a
repair or correct an error, clear the system-event log to turn off the system-error
LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the POST error
messages.
– System Event Log
Select this choice to view the IMM system event log.
– Clear System Event Log
Select this choice to clear the IMM system event log.
Select this choice to set, change, or clear passwords. See "Passwords" on page
407 for more information.
This choice is on the full and limited Setup utility menu.
– Power-on Password
Select this choice to set or change a power-on password. See "Power-on
password" on page 407 for more information.
– Administrator Password
Select this choice to set or change an administrator password. An
administrator password is intended to be used by a system administrator; it
limits access to the full Setup utility menu. If an administrator password is
set, the full Setup utility menu is available only if you type the administrator
password at the password prompt. For more information, see "Administrator
password" on page 409.
Select this choice to save the changes that you have made in the settings.
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
Select this choice to cancel the changes that you have made in the settings and
restore the factory settings.
Select this choice to exit from the Setup utility. If you have not saved the
changes that you have made in the settings, you are asked whether you want to
save the changes or exit without saving them.