IBM x3690 X5 Service Manual page 368

12. Release the microprocessor retention latch by pressing down on the end,
13. Open the microprocessor bracket frame by lifting up the tab on the top edge.
14. Locate the microprocessor installation tool that comes with the new
15. Align the holes on the installation tool with the screws on the microprocessor
350
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide
Heat sink
release lever
Lock tab
moving it to the side, and releasing it to the open (up) position.
Keep the bracket frame in the open position.
Microprocessor
release lever
microprocessor.
Note: If you are removing E7 series microprocessors, you must use the
microprocessor installation tool with the text "X7500 + E7" on the bottom of
the tool (see the following illustration). Tools that do not have this text on the
bottom will not work correctly with the E7 series microprocessors.
X7500
+
E7
bracket, then place the microprocessor installation tool down over the
microprocessor 1 . Twist the handle clockwise 2 to attach the tool to the
microprocessor.
Flange
Microprocessor
Retention
module
Slot
opening
Microprocessor
bracket frame