Replacing The Max5 Information Panel Assembly - IBM x3690 X5 Service Manual

Replacing the MAX5 information panel assembly

To replace the MAX5 information panel assembly, complete the following steps:
1. Read the safety information that begins on page "Safety" on page vii and
2. From the front of the MAX5 system-board tray, insert the cable end of the
3. Insert the tab on the left side of the information panel assembly into the hole
4. Push the information panel assembly release latch in firmly to snap the release
5. Connect the information panel assembly cable to the connector on the system
6. Slide the system-board tray forward until the tabs at the bottom of the handles
380
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide
"Installation guidelines" on page 261.
information panel assembly through the information panel slot.
on the system-board tray and hold the information panel assembly release latch
while you rotate the right side of the assembly toward the system-board tray.
latch into place and secure the information panel assembly.
board.
touch the chassis; then, close the release latches firmly (they will snap into the
locked position).
Slot
Tab
Information
panel assembly
Release
latch