IBM x3690 X5 Service Manual page 408

Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any component
that has this label attached. There are no serviceable parts inside these
components. If you suspect a problem with one of these parts, contact a service
technician.
To remove a hot-swap power supply from the MAX5 expansion module, complete
the following steps:
1. Read the safety information and installation guidelines, see "Safety" on page vii
2. If only one power supply is installed, turn off the host server and peripheral
3. If the MAX5 is in a rack, at the back of the MAX5, pull back the cable
4. Press and hold the orange release tab to the left. Grasp the handle and pull the
5. If you are instructed to return the power supply, follow all packaging
390
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide
and "Installation guidelines" on page 261.
devices and disconnect the MAX5 power cords.
management arm to gain access to the rear of the MAX5 and the power supply.
power supply out of the MAX5.
Power
supply
release tab
Power
supply
instructions, and use any packaging materials for shipping that are supplied to
you.