Removing the MAX5 air baffle
To remove the air baffle in the MAX5, complete the following steps:
1. Read the safety information and installation guidelines, see "Safety" on page vii
and "Installation guidelines" on page 261.
2. Turn off the host server (see "Turning off the server" on page 17) and all
attached peripheral devices. Disconnect all power cords; then, disconnect all
external cables from the server. Disconnect all power cords from the MAX5;
then, disconnect all external cables from the MAX5 as necessary to replace the
device.
3. Remove the bezel (see "Removing the MAX5 bezel" on page 376).
4. Remove the system-board tray (see "Removing the MAX5 system-board tray
assembly" on page 394).
5. Press the air baffle release tab in and lift the air baffle out of the slot on the
system-board tray wall (near the rear of DIMM 1) to release it; then, push the
air baffle forward sightly to unhook it from the system board and set it aside.
Release
latch
Alignment tab
Slot
Tab
Alignment
tab
Release
tab
Chapter 5. Removing and replacing components
Alignment
tab
Release
tab
Bezel
377